RTS-Brake Module | spokeworks-led

Rear Turnsignal (RTS)-Brake Module Installation Instructions

The modules are plug-n-play.

There are 6 wires:

Brake In and Out (RED)

Turnsignal In and Out (BLACK) Turnsignal OUT has 2 connectors for the configuration of RTS/Brake + RTS/Brake

Ground In and Out (BROWN)

There is one module for each light housing.

The wires intercept the OEM wires to the housing.

The OEM wires connect to the male spades; the female spades connect to the housing.

There are 2 sizes of heat shrink tubing.
Small (2 pieces) to cover the OEM turnsignal spades which may not be covered.
Large (2 pieces) to cover the unused RTS OUT connector from the module.
Use the Large heat shrink tubing to cover one of the RTS OUT connectors.
Use the Small heat shrink tubing to cover the OEM RTS spade if not covered.
Remove one wire at a time and connect In and Out wires to the OEM wire and the housing.
Test the units
When completed, tuck the module under the rear light housing as neatly as possible.

There are 2 sizes of heat shrink tubing.
Small (2 pieces) to cover the OEM turnsignal spades which may not be covered.
Large (2 pieces) to cover the unused RTS OUT connector from the module.
Use the Large heat shrink tubing to cover the BRAKE OUT connectors.
Use the Small heat shrink tubing to cover the OEM RTS spade if not covered.
Remove one wire at a time and connect In and Out wires to the OEM wire and the housing.
Test the units
When completed, tuck the module under the rear light housing as neatly as possible.